Edirol VC-50HD Manual do Proprietário

Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (p. 3-5; p. 6-7). These sections provide

10Main featuresConversion between HD/SD-SDI and HDV/DVThe VC-50HD provides a compact solution for converting between high-quality uncompressed HD/SD-S

11The VC-50HD’s conversion capabilitiesThe format of the input to the VC-50HD is detected automatically. The VC-50HD is capable of performing conversi

12Names of things and what they doFront panelfig.VC50-front.eps1. HD/SD-SDI input connector and indicatorThis connector allows SDI signals to be input

13Names of things and what they doSide panel1. USB connectorThis can be connected to your computer, allowing the VC-50HD’s settings to be switched via

14Placement and connectionsCooling ventsDo not block the cooling vents located on the sides of the VC-50HD. When placing the VC-50HD, make sure to lea

15Power supplyIn addition to being powered by the AC adaptor, the VC-50HD can also be powered by AA batteries in the internal battery case, or by an e

16Power supplyInstalling AA batteriesInstall commercially available AA batteries into the VC-50HD, following the procedure described below.* Zinc-carb

17Power supply3.Install eight AA batteries in the battery caseTaking care to observe the correct polarity ( orientation), insert the batteries in acco

18Power supplyAttaching an external batteryIf you want to supply power from an external battery, you must first attach the holder included with the VC

19Power supply3.Fasten the battery plate and holder to the top of the VC-50HDUsing the four included screws, fasten the battery plate and holder that

20Turning the power on/offTurning the power onAfter you have made connections correctly, you must turn on the power as described below. Incorrect oper

21Turning the power on/offTurning the power offSlide the POWER switch in the direction of the arrow and hold it for two or three seconds until the POW

22Connections with video devicesThis section explains the types of conversions and mode settings provided by the VC-50HD. The correct mode setting mus

23Connections with video devicesMode settings to output HDVFor converting HD-SDI to HDV, make the following mode settings.* For HDV connection to a co

24Connections with video devicesConverting IEEE 1394 to SDIA signal can be input from an HDV/DV device or computer equipped with an IEEE 1394 (i.LINK)

25Connections with video devicesUsing the VC-50HD with the Edirol F-1If the VC-50HD is used with the Edirol F-1 (version 2 or later), the output from

26Connecting Monitors/MixersConnecting monitor equipmentThe VC-50HD provides an HDMI output connector. You can set up an inexpensive monitoring enviro

27Other mode settingsBy setting the mode select switches located on the VC-50HD’s side panel, you can select the audio channels that will be output, a

28Other mode settingsAccepting remote controlThe VC-50HD can be remotely controlled by a computer connected to its USB connector or by an Edirol F-1 (

29AppendicesTroubleshootingIf you suspect a malfunction, please check the following points before you contact us. If this does not solve the problem,

3USING THE UNIT SAFELY002c• Do not open (or modify in any way) the unit or its AC adaptor...

30AppendicesMain Specificationsfig.spec-sheet.eps* In the iinterest of product improvement, the specifications and/or appearances of this unit are sub

31AppendicesDimensionsfig.dimension.epsBlock Diagramfig.block-diagram.eps90100. 848. 21340211111428170159Unit : mmSDI RXSDI TXHDMI TXENCODE / DECODEHD

32AppendicesTimecode•Supported timecodeSee “Main specifications” (p. 30)•TC input priority orderVITC and LTC ancillary timecode (SMPTE RP 188) is supp

33Appendices

34MemoMemo

For EU CountriesFor China

For the USADECLARATION OF CONFORMITYCompliance Information StatementModel Name :Type of Equipment :Responsible Party :Address :Telephone :VC-50HDConve

* 5 1 0 0 0 0 5 9 0 4 - 0 1 *

4USING THE UNIT SAFELY009• Do not excessively twist or bend the power cord, nor place heavy objects on it. Doing so can damage the cord, producing sev

5USING THE UNIT SAFELY101b• The unit and the AC adaptor should be located so their location or position does not interfere with their proper ventilati

6IMPORTANT NOTESPower Supply: Use of Batteries301• Do not connect this unit to same electrical outlet that is being used by an electrical appliance th

7IMPORTANT NOTESMaintenance401a• For everyday cleaning wipe the unit with a soft, dry cloth or one that has been slightly dampened with water. To remo

8ContentsCheck the included items ...... 9Main features ...

9Check the included itemsThe VC-50HD itselffig.VC50-itself.epsBattery casefig.battery-case.epsAC adaptor and power cablefig.PSB1U.eps* A ferrite core